Hot Wire Foam Factory Bounce Rubberizer, 16 oz

Item #: 87646
851766005163Hot Wire Foam Factory
Our Price $15.95
Our Price $15.95

Incredible Bouncing Boulders? Add small amounts of All Purpose Foam Coat to Bounce to create a flexible protective coating that is highly resistant to cracking on impact. Also makes All Purpose Foam Coat weatherproof, stick even better, and stronger with very thin coats. Use with 1-80 lbs. of dry All Purpose Foam Coat.

Mixing: Use Bounce with no added water for maximum flexibility. All Purpose Foam Coat comes out more flexible when no or less water is added to the Bounce. For a super rubbery coating, try a liquidy mixture of 9 parts Bounce to one part All Purpose Foam Coat, adding the powder to the Bounce, until the desired thickness is attained.

Can also be applied alone, or with just a little bit of Foam Coat to create a strong flexible paintable sealant. For a chip resistant coating, start with 1 part liquid to 1 part All Purpose Foam Coat, and thin or thicken as desired. Dilute the Bounce with water before mixing with Foam Coat to get a less flexible, super smooth, chip-resistant surface.

Thin layers can be applied to vertical and inverted surfaces with little or no sagging. Applying: Fill holes with pasty mixture. To coat large areas, make a more liquidy mixture until thin enough to apply with a paint brush. May be applied as thick as 3/8 inch, but multiple coats are stronger. Looks like smooth stone when dry. Try texturing the surface before coating sets. Bounce is compatible with our Grit Texturizers (#87648 and #87469). Can be smoothed while drying, but not sandable once dry.

Set Time: Use within 15 minutes. Sets up in 30 minutes. Maximum bond and strength in 24 hours.

Clean-Up: Immediately clean tools and brushes with soapy water.

Finishing: Paint or stain as desired.

Note: This item ships direct from California to contiguous 48 states only.

Customer Reviews of This Item

No reviews available

Be the first to Write a Review