
Caoutchouc de silicone platine Rebound 25 à brosser, taille d'essai, 2 lb
UGS
Rebound™ 25 est un caoutchouc de moule doux et flexible, idéal pour fabriquer des moules de modèles avec des contre-dépouilles profondes.
Rebound™ 25 est un caoutchouc de silicone à durcissement au platine facile à utiliser qui s'épaissit automatiquement pour fabriquer des moules à appliquer au pinceau de presque tous les modèles. Mélangé 1A:1B en volume (aucune échelle nécessaire), le caoutchouc Rebound™ peut être appliqué avec un pinceau ou une spatule sur des surfaces verticales sans affaissement et durcira avec un retrait négligeable pour devenir un caoutchouc flexible. Rebound™ n'adhère pas à la plupart des surfaces, la préparation de la surface est donc minime. 4 fines couches suffisent pour réaliser un moule de production souple, solide et durable pour couler de la cire, du gypse, du béton ou des résines (uréthane, polyester...). Et comme Rebound™ est un silicone platine, il durera de nombreuses années dans votre bibliothèque de moules. Les applications incluent la reproduction de sculptures, la restauration architecturale, la fabrication de moules à bougies, le moulage d'étain, etc.

Product specifications
Brand | |
---|---|
Weight | |
Dimensions | |
Warranty | |
Back in Stock Date | N/A |
Expédition & retours
Nous espérons que vous serez entièrement satisfait de votre commande... mais si un article ne répond pas à vos attentes, vous pouvez le retourner comme neuf dans les 30 jours suivant la livraison pour un remplacement, un échange ou un remboursement du prix d'achat.
More Information:
Note: These products will not work under any circumstances with modeling clays containing sulfur.Instructions:
Safety Use in a properly ventilated area (“room size” ventilation). Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk. Wear vinyl gloves only. Latex gloves will inhibit the cure of the rubber.
Store and use material at room temperature (73°F/23°C). Warmer temperatures will drastically reduce working time and cure time. Storing material at warmer temperatures will also reduce the usable shelf life of unused material. These products have a limited shelf life and should be used as soon as possible.
Cure Inhibition The curing of silicone rubber may be inhibited by certain contaminants in or on the pattern to be molded resulting in tackiness at the pattern interface or a total lack of cure throughout the mold. Latex, sulfur clays, certain wood surfaces, newly cast polyester, epoxy or urethane rubber my cause inhibition. If compatibility between the rubber and the surface is a concern, a small-scale test is recommended. Apply a small amount of rubber onto a non-critical area of the pattern. Inhibition has occurred if the rubber is gummy or uncured after the recommended cure time has passed. To prevent inhibition, one or more coatings of a clear acrylic lacquer applied to the model surface is usually effective. Allow any sealer to thoroughly dry before applying rubber.
Important: Even with a sealer, Rebound™ will not work with modeling clays containing sulfur. If you are not sure if your clay contains sulfur, do a small compatibility test before using for an important project.
Applying A Release Agent Although not usually necessary, a release agent will make demolding easier when casting into most surfaces. Ease Release #86627 is a proven release agent for releasing silicone from silicone or other surfaces.
Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.
For more information, go to: www.P65Warnings.ca.gov