Hot Wire Foam Factory Boost Liquid Fortifier, 16 oz

MIXING: Mix with 50% water for maximum strength. Thin more where less strength is needed. Always add the Foam Coat to the liquid. Start with 1 part liquid to 3 parts Foam Coat, and thin or thicken as desired. Thinning the Foam Coat with more Boost will not weaken it.

APPLYING: Fill large cracks and holes with pasty mixture. To coat large areas, add more liquid until thin enough to apply with a paint brush. May be applied as thick as 3/8 inch, but multiple coats are stronger. Try texturing surface before coating sets.

SET TIME: Use within 10 minutes. Sets hard in 30 minutes. Add acrylic paint to extend use time. Maximum bond and hardness in 24 hours.

CLEAN-UP: Immediately clean tools and brushes with soapy water. Boost cannot be removed once dry.

FINISHING: May be painted or stained.



Suggested Dilutions Boost : Water

Super Strong 1 : 1

Very Strong 1 : 2

Strong 1 : 3

Note: This item ships direct from California to contiguous 48 states only.

We hope you will be completely satisfied with your order...but, if an item does not meet your expectations, you may return it in as-new condition within 30 days of delivery for a replacement, exchange or refund of the purchase price.

--- Australia Austria Belgium Canada Czechia Denmark Finland France Germany Hong Kong SAR Ireland Israel Italy Japan Malaysia Netherlands New Zealand Norway Poland Portugal Singapore South Korea Spain Sweden Switzerland United Arab Emirates United Kingdom United States Country

Province

Zip code

Estimate