Prompt delivery. Works as I hoped

Great to find that the quality of the mini brass nails is identical to that of the ones I had bought many years ago and recently used up!

Works great will buy from micro mark again

I replaced a Blue Box Athern motor with the 2430. It has plenty of torque plus runs quietly. The motor will also fit in a narrow shell. Much of my motive power fleet dates back to the seventies and most run very well. I decided to purchase more of these motors if I need to remoter more units and the price is very reasonable.

being partially handicapped, easy tool to use

Effortlessly separates sprue with good flat cut. Almost no need for filling.

great product. exactly what I needed.

Very small yet very sharp and has the ability to saw wood in very tight areas.

Great product.

Nice container and bits as advertised

Has some 28g wire to strip. My old pair stops at 24g so I tried this. Love it. Nice a sharp. No more hitting myself in the face when the insulation comes off. Insulation just slid off with zero nicks on stranded wire. My new go to stripper.

I've used a lot of brands of paint over the last 50+ years, so I wasn't sure what to expect when I ordered. I've been very pleased with the colors which work well without mixing and equally well mixed for more variation. The paints brush, flow well and dry to a very matte finish. My only negative comments would be, first, that they are a bit on the thick side and need to be thinned a little to get a nice working texture and, second, that a bit more reference to uniform colors, FS or ANA numbers, etc. be included. Otherwise, first rate! I'm hoping that we see colors for other countries as well.

Well made, and a great addition to the Micro-Mark tilt arbor saw! Very limited on length, but that’s something you just have to deal with when using mini tools!

A must have if you use the Micro-Mark tilt arbor table saw!

I already own a Proxxon FET mini table saw, but needed a second one. The Micro Mark saw is similar, and about $100 less, so i went with it. Two things that i feel are great features on the MM saw, and not present on the Proxxon, are the fence that extends the whole length of the table and clamps front and rear, and the variable speed control. I had some difficulty adjusting the miter gauge to get an accurate 90 degree cut, the normal squaring of the gauge to the blade not resulting in an accurate cut! The fix wound up being to make many cuts and adjusting each time until i found 90 degrees! I almost sent it back after my first few cuts, but after adjustment, i hung on to it. Plenty of power, and the included blade amazingly does a clean cut!